12.3.3
On demand transmission with G.L.P.
In the ''on demand transmission'' with G.L.P., the data transmitted to the computer is the same
as described as in the ''on demand transmission'' without G.L.P. mode but with adding the G.L.P.
parameters before each transmission, as described below:
12.4
CONNECTION OF BALANCE WITH SERIAL PRINTER
It is possible to connect the balance to a peripheral printer.
To print the weight, connect the connector of the balance to the serial printer as shown in the
scheme below:
Here you can find description of the several modes of printing that can be selected:
•
Print of weight data with a generic serial printer (from the menu, set the generic printing
mode as described in the paragraph 10.2 and manage the busy signal).
•
Print of weight data together with GLP indications with generic serial printer (from the
menu, set the generic printing-GLP mode as described in the paragraph 10.2 and
manage the busy signal)
•
Print of weight data with printer model ATP50 (from the menu, set the printer ATP mode
as described in the paragraph 10.2).
•
Print of weight data together with GLP indications with printer model ATP50 (from the
menu, set the printer ATP - GLP mode as described in the paragraph 10.2).
Note: In all different printing modes just described, if the weight is not stable during
transmission of data to printer, an audible bleep is emitted and ERR05 is displayed and
weight is not printed.
©Adam Equipment Co. Ltd. 2018
64