Water Inlet Strainer Inspection; Bilge Pump; Bilge Strainer Inspection - Yamaha WaveRunner FX140 Manuel D'entretien

INSP
ADJ
1
JET PUMP UNIT/BILGE PUMP

Water inlet strainer inspection

1. Inspect:
• Water inlet strainer
Contaminants → Clean.
Cracks/damage → Replace.
Inspection steps:
• Remove the ride plate.
Refer to "INTAKE GRATE, RIDE PLATE,
AND INTAKE DUCT" in Chapter 6.
• Remove the rubber plate.
Refer to "JET PUMP UNIT" in Chapter 6.
• Remove the water inlet cover 1.
• Inspect the water inlet strainer mesh a.
• Install the water inlet cover.
• Install the rubber plate.
Refer to "JET PUMP UNIT" in Chapter 6.
• Install the ride plate.
Refer to "INTAKE GRATE, RIDE PLATE,
AND INTAKE DUCT" in Chapter 6.

BILGE PUMP

Bilge strainer inspection

1. Inspect:
• Bilge strainer
Contaminants → Clean.
Cracks/damage → Replace.
Inspection steps:
• Remove the deck beam.
Refer to "SEATS AND HAND GRIP" in
Chapter 8.
• Remove the coupling cover.
• Disconnect the bilge strainer 1 from the
bilge strainer holder.
• Inspect the bilge strainer.
• Install the coupling cover.
• Install the deck beam.
Refer to "SEATS AND HAND GRIP" in
Chapter 8.
3-27
E