Stryker GoBed II Lit MedSurg FL28EX Guide D'utilisation page 31

Lit d'hôpital ajustable
Masquer les pouces Voir aussi pour GoBed II Lit MedSurg FL28EX:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

The monitor tray is designed to hold and secure a monitor using a Velcro strap . The tray can also be used as a writing
support . It folds down into a storing position .
WARNING
The scale and bed exit systems must be adjusted if this accessory is added when either system is in operation . Refer to
the "Add / Remove Equipment" procedure
INSTALLATION
Tools Required:
• None
Procedure:
1 .
Insert the monitor tray posts into the I . V . pole holders located on the foot end of the unit .
OPERATION
CAUTION
• Do not use the monitor tray as a push/pull device .
• Do not use an I . V . pole at the foot end of a unit equipped with this device .
1 .
To use the tray for monitor support, pull the lock pin (A), lift the tray and fold it back toward the head end of the
bed, and release the pin .
2 .
To use the tray for writing support, pull the lock (A) and lift the tray to about 30 degrees and release the pin .
3 .
To place the tray into its stored position, pull the lock pin (A), lower the tray to its lowest position and release the pin .
Note: Secure the monitor to the tray using the Velcro strap .
WARNING
The maximum load capacity of the tray is 40 lb (18 kg) .
www.stryker.com
Monitor Tray - FA64163
(page
1-21) .
28EX-009-001 REV B
Lock pin
Return To Table of Contents
1-29

Publicité

Chapitres

Table des Matières
loading

Table des Matières