Traction Adapters - Stryker GoBed II Lit MedSurg FL28EX Guide D'utilisation

These adapters allow for the installation of traction frames . This applies to FA64188, FA64189, FA64190 and FA64191 .
WARNING
The scale and bed exit systems must be adjusted if this accessory is added when either system is in operation . Refer to
the "Add / Remove Equipment" procedure
INSTALLATION
Tools Required:
• 1/2" Combination Wrench
Procedure:
1 . Install the four adapters (A) into the corresponding holes located in the corners of the bed .
2 . Using a 1/2" combination wrench, secure the washers (B) and bolts (C) provided .
Note: The bolt is coated with "Scotch Grip" . The coating becomes less effective once the bolt is tightened and removed
thereafter . Replace the bolt if the traction adapter is removed and reinstalled on another bed .
Return To Table of Contents
1-42

Traction Adapters

(page 1-21) .
A
C
B
28EX-009-001 REV B www.stryker.com