Stryker GoBed II Lit MedSurg FL28EX Guide D'utilisation page 37

Bed Extender with Scale - FA64172
INSTALLATION (CONTINUED)
• For an 80" mattress, assemble the support on the bed extender using the screws provided with a #2 Phillips
screwdriver . Do not move the foot end mattress retainer, it is positioned for an 80" mattress from the factory .
See the "Configuration with 80" Mattress" illustration on
• For an 84" mattress, move the foot end mattress retainer to the position nearest to the bed extender foot end
by pressing inward on its lateral pins . Do not assemble the support to the extender . See the "Configuration with
84" Mattress" illustration on
5 . Insert the mattress support extension posts into the foot board mounting sockets .
6 . Install the cushion onto the bed extender . Do not use the cushion straps; squeeze the cushion between the mattress
end and the mattress retainers on the bed extender . See the illustration below .
7 . Insert the foot board into the mounting sockets on the bed extender .
8 . Verify proper operation of the unit before returning it to service .
WARNING
The bed extender must be removed before using the emergency crank (optional) .
www.stryker.com
page
page 1-34 .
Bed Extender Cushion Installed
28EX-009-001 REV B
1-34 .
Return To Table of Contents
1-35