Mixer Cleaning And Shutdown - WAGNER PLASTMAX Mode D'emploi

GB
7
MIXER CLEANING AND
SHUTDOWN
After the work, carry on pumping until the container and the
material hoses are empty.
Attention! Before removing the spray lance
or the hoses, always make sure that there is
no residual pressure. Watch the manometer
––> 0 bar.
Run the machine in reverse to relieve the pressure.
Turn the main switch to 0 to switch off the machine.
Remove the in-wall lance and clean as follows:
- Clean the texture tip (fig. 14, 1).
- Clean the air holes with a cleaning needle
- Clean and lubricate the O-ring (fig. 14, 2).
- Clean the spray lance and material tube on the inside using a
bottle brush (0342329).
- Clean all threads thoroughly.
- Rinse the spray lance with clear water. Open and close the
material tap three times as you are doing this.
Decouple the mortar hose from the outlet unit.
Insert cleaning ball into mortar hose
Connect the mortar hose to the cleaning connection (fig. 15, 3).
Switch on the water pump and open the water tap until the
cleaning ball emerges at the other end.
Repeat the procedure until the hose is cleaned properly.
Release the quick-release connection with the guard and open
the mixing chamber in the container. (Fig. 16)
Take out the mixer (fig. 16, 1) and wash it.
Clean the mixing area with a spatula.
Insert the cleaning tool and hook up to the gear motor at the
connection. (Fig. 17)
Switch on the machine until the cleaning procedure has com-
pleted.
Stop the machine and remove the cleaning tool.
Install the clean mixer again.
After the machine has been cleaned, switch off the main switch,
disconnect the power supply from the plug, close the water
supply, turn on the additional tap for a few seconds and then
disconnect the supply hose.
If there is any indication of frost whatsoever, turn on the
four taps (fig. 18) of the water system and drain all the water
out of the water system.
The taps have to be turned off again before the machine is put
into operation.
44
2
3
PlastMax
1
1