Technical Data; Preparation Of Workplace And Coating Substance - WAGNER WALLROLLER TURBOROLL 550 Mode D'emploi

TurboRoll 550
Voltage
Max. volume
Paint container
Ambient temperature
Storage
Paint roll
Weight

PREPARATION OF WORKPLACE AND COATING SUBSTANCE

•
Before commencing work cover floor, furniture, door frame and other objects or mask
with adhesive tape.
•
Place the device and the paint container on an adequately large piece of sheeting or
cardboard.
•
Stir the paint well and dilute by up to approx. 10 % if necessary (adhere to manufacturer's
instructions).
SETUP
1. Insert the batteries in accordance with the marking (Fig. 1).
Remove the plastic bag from the piston rod.
2. Grease the O-rings on the front of the piston rod evenly. (Fig. 2)
3. Insert the piston rod into the paint cylinder. Take care not to twist or damage the O-rings.
(Fig. 3)
4. Tighten the union nuts in order to fix the piston rod and the cover of the battery
compartment. (Fig. 4).
5. Assemble roller cover, core and cap. (Fig. 5)
6. Attach assembly to the roller arm, making sure the roller assembly snaps into the locking
tab (Fig. 6, a).
7. Press the quick-release tabs on the unit (Fig. 7, a) and attach the arm to the handle
(Fig. 7, b).
8. Place the suction tube through the fixing clip. (Fig. 8)
9. Attach the clip to the side of the paint can, making sure that the fill tube is submerged
into the paint. (Fig. 5)
FILLING THE TURBOROLL
Push the filling valve firmly onto the suction tube with one hand. (Fig. 10)
Set the lever to "POWER" (Fig. 11, a). Hold the switch pressed back (Fig. 11, b), in order
to move the piston rod back and fill the paint cylinder with paint.
Alternatively, you can set the lever to "MANUAL" and pull the piston rod back by hand.

Technical data

6 V
1.2 l/min
550 ml
10°C to 43°C
-23°C to 49°C
Nap height 20 mm, width 230 mm
approx. 1.2 kg
TM
GB
9