Further Potential Errors - WAGNER PLASTMAX Mode D'emploi

GB
10.2

FURTHER POTENTIAL ERRORS

MALFUNCTION
Machine is not starting
Neither machine nor compres-
sor can start and the blue pilot
lamp is off
The machine cannot start, but
the compressor starts
48
POSSIBLE CAUSE
Water
- Water pressure is too low: The mano-
meter is indicating a pressure below
2 bar (is the green pilot lamp on?),
the display is showing H2O
Material
- Product in mixing chamber is too
dry (mortar pump blocked? Is red
pilot lamp on?)
Air
- Air pressure does not go under the
minimum pressure of the machine
pressure switch when gun tap is fully
open
Guard
- The guard is not mounted correctly,
the display shows Bloc
Controller
- Control cable is not connected (for
automatic mode)
- The controller for pneumatic mode
is set to "Automatic"
- The controller for automatic mode is
set to "Pneumatic"
- No current at plug on building-site
circuit board (fuses?)
- No power supply to machine (con-
nection plug defect? Cable broken?)
- The main switch is not switched on
- Operating switch has not been acti-
vated
- Signal for pressure switch for min.
water pressure at start (is the water
pump switched on? See also "Machi-
ne does not start", cause water)
ELIMINATION
- Check whether water is leaking out of the sup-
ply line
- Check to see if the water filter is clean
- Check to see if the water pump is switched on
- If the pump is drawing water from a tank, check
to see if it fills correctly the first time, and make
sure that the connections are not leaking
- First machine start not correct (see chapter 5)
- Water throughout is set too low (see chapter
4.2)
- No water supply to mixing chamber (water in-
put blocked, water magnet valve is not functio-
ning)
- Check to see if air hose is bent or blocked
- Check to see if spray nozzle really is clean
- Mount guard correctly
- Connect control cable (see chapter 4.2)
- Switch to "Pneumatic"
- Switch to "Automatic"
- Check points listed alongside
- Check points listed alongside
PlastMax