General Information About The Application Technique; Shutting Down And Cleaning; Cleaning The Mortar Hose; Cleaning The Device And Replacing The Stator - WAGNER Plast Coat 430 Mode D'emploi

GB

GENERAL INFORMATION ABOUT THE APPLICATION TECHNIQUE

7
GENERAL INFORMATION ABOUT
THE APPLICATION TECHNIQUE
7.1
SPRAYING TECHNIQUE
be uneven.
Examples:
Fine texture
Rough texture
Higher convey capacity –> larger amount of atomizing air
Test the desired texture on a test surface.
lapping of the next coat.
the surface to be coated, the paint mist is minimized.
Note:
Grains and pigments with a sharp edge result in a high rate of
wear of the pump, mortar hose, material tap and tip.
When using the mortar hose while working
hose along the outside of the scaffolding.
8

SHUTTING DOWN AND CLEANING

Do not clean the motor and control unit of
the mortar spraying machine moistly. And
certainly do not spray down the unit with
high-pressure cleaners or high-pressure
steam cleaners. Danger of short-circuits
caused by water ingressing.
8.1

CLEANING THE MORTAR HOSE

sel/bucket.
Important: Do not let the mortar spraying
machine run dry. Switch the device off im-
mediately if no more material comes out of
the tip or if the spray line becomes irregu-
lar. Possible reasons for the problem and
how to correct it can be found in the chap-
ter called „Eliminating faults".
46
–> large amount of atomizing air
–> small amount of atomizing air
using pneumatic lance, set selector switch to "F".
exiting the hose is just a thin liquid.
using pneumatic lance, set selector switch to "A".
The mortar hose must be pressureless.
If necessary, set the selector switch briefly
to "R" (reverse).
Watch the manometer ––> 0 bar.
Wear safety goggles.
-
-
hose
cleaning process 3 – 4 times.
The mortar hose must be pressureless.
If necessary, set the selector switch briefly
to "R" (reverse).
Watch the manometer ––> 0 bar.
Wear safety goggles.
A further cleaning option is to use the clean-
This cleaning adapter can be connected to a
pling.
Insert cleaning ball into the mortar hose. Cou-
ple the mortar hose to the cleaning adapter
and rinse through with water.
8.2
- CLEANING THE DEVICE AND REPLACING THE
STATOR
To do so, pump graphite pump sliding means or water mixed
with dishwashing liquid through the pump.
Plast Coat 430
-