Operating Elements And Displays On Device (Fig. 2) - WAGNER PLASTMAX Mode D'emploi

GB
2.5

OPERATING ELEMENTS AND DISPLAYS ON DEVICE (FIG. 2)

1 Main switch: Switches machine on (I) and off (0)
2 Selector switch for operating mode:
Pneumatic = Operation with pneumatic spray lance
Automatic = Operation with automatic spray lance
3 Indicating lamp (blue): indicates presence of line voltage
4 Speed regulator (+ and -): The selected speed (1 to 4) is
shown in the display
5 Display
6 Selection switch for conveyor pump:
Conveyor pump is at standstill
Forwards motion gear: The material is con-
veyed to the spray lance
Reverse gear: The conveyor pump runs in
reverse. For example to relieve pressure
7 Error display (red): Lights up when a problem is incurred.
An error code is also shown in the display
8 On/Off switch for water pump: Switches on water pump
as required (position I)
9 Pilot lamp for water pump (green): Lights up when the
pump is switched on to supply water
10 Water supply: Press to switch the water supply on and off
11 When the EMERGENCY STOP switch is pressed, the Plast-
Max is switched off immediately.
Turn the EMERGENCY STOP switch in order to release it
again. The machine remains switched off after release.
To switch it back on again, the main switch has to be
pressed again.
12 Water volume regulator: The required volume of water is
set by turning the regulator
13 Water flow meter: Shows the set volume of water
36
11 7
10
8
9
12
13
PlastMax
5 6 1
Pneumatic Automatic
4 3
2