Premixed Material - WAGNER PLASTMAX Mode D'emploi

GB
Open material tap (Fig. 12, 16) on spray lance (material tap at
90° to spray lance).
If cellulose paste comes out of the tip, close the material tap
(fig. 12, 16) (material tap points forwards).
The machine is now ready for operation.
5.2

PREMIXED MATERIAL

To avoid blockages, the mortar hose should
be rinsed. Attention! Water is not sufficient
as a sliding means. Danger of clogging!
Use cellulose paste (e.g. Metylan wallpaper
paste, art no. 2312136).
Set the selector switch for the operating mode (fig. 11, 19) to
pneumatic (for pneumatic lance) or automatic (for automatic
lance).
Fill cellulose glue into the mortar hose, connect to the material
outlet and secure with a clamping lever (4).
Fill the container with the premixed material.
Turn the main switch (fig. 11, 1) on the switch panel to 1 in order
to switch on the compressor.
Activate the two buttons (fig. 11, 3) until the operating modes
2 or 3 are shown on the display (4).
Turn the start switch (fig. 11, 5) to operating position (to the
right).
Hold spray lance over an empty bucket.
Close the air flow regulator (fig. 12, 15).
Open material tap (Fig. 12, 16) on spray lance (material tap at
90° to spray lance).
If cellulose paste comes out of the tip, close the material tap
(fig. 12, 16) (material tap points forwards).
The machine is now ready for operation.
42
10 6
9
7
8
13
14
15
PlastMax
4 5 1
Pneumatic
3
2
17
18
12
16
Automatic
19