Connecting The Motar Hose; Connecting The Spray Lance - WAGNER PLASTMAX Mode D'emploi

GB
4.3
CONNECTING THE MORTAR HOSE
Connect the mortar hose (fig. 9, 3) to the material outlet and
secure it with a clamping lever (4).
When using an air hose with a quick connector: Mount the
included adapter (7) to the air connection (8).
Connect the atomiser connection (6) on the mortar hose to the
adapter (7) or air connection (8).
When using the automatic version: Screw the remote control
to the connector (5).
6
40
4 3
7 8
4.4
CONNECTING THE SPRAY LANCE (FIG. 10)
A number of different sized nozzles are included in
the accessories. A small nozzle diameter produces
fine atomisation. Nozzles with a larger diameter are
best for large-grained materials. The tip size should
amount to at least three times the granular size,
e.g. granular size artificial resin plasters –> 3 mm
Tip size –> 10 mm
Select a spray tip suitable for the material.
Make sure that the air hole
remains free. If necessary
clean with the cleaning pin
(0342 916).
Connect the rendering tip (fig. 10, 3) to the rendering lance.
Connect the rendering lance (1) to the material hose and secure
by applying the levers (8).
Connect atomization air connection (7) to the air hose of the
mortar hose.
Automatic version only: Screw coupling plug (5) for remote
control to the control cable of the mortar hose.
8
7
5
5
PlastMax
2
1
3