WAGNER PLASTMAX Mode D'emploi page 47

PlastMax
ERROR MESSAGES POSSIBLE CAUSE
IN THE DISPLAY
BLOC
- The spiral pump motor is blocked
STOP
- Warning message air to closed lance
- Gun nozzle / air pipe blocked, the
machine cannot start after break
H2O
- Water pressure below 2.5 bar; insuf-
ficient throughput/pressure for cor-
rect functioning
- The machine has switched itself off
and on again; the display is flashing
H2O for several seconds.
- Air in pipe/system
- Automatic lance is closed
ELIMINATION
- Check to see if stator and rotor are wedged together (dis-
mantle and free/replace)
- Remove foreign body from funnel/from mixing chamber
- Open lance
- Clean air nozzle, unblock the air pipe
- Switch on the machine's water pump
- Check to see if the filter in the hydraulics system of the machi-
ne is clean
- Let water run out of the drain tap in order to vent the pipe/sys-
tem
- There is no error
GB
47