Electric Safety; Motar Hose; Mortar Hose - WAGNER PLASTMAX Mode D'emploi

PlastMax
Before any cleaning or maintenance work is carried out, switch
off the mixing pump. Unplug the power plug from the outlet. Do
not decouple the mortar hose under pressure. Before decoupling
watch the pressure at the manometer.
Never spray off the device with a power spray and especially not
with a high-pressure cleaner or high-pressure steam cleaner. Dan-
ger of short-circuits caused by water ingressing!
1.3

ELECTRIC SAFETY

The PlastMax mixing pump meets the requirements stated in
directive EN 60204-1 and is protected against sprays of water,
overloading and power failures.
The mixing pump must be grounded.
Connection to the mains network only via a special feeding point,
for example via a distribution board for construction sites, with
residual current protective device with INF ≤ 30 mA. RCD Type B
with 30 mA recommended.
The power lines must be laid to prevent any possible damage.
Never place the mixer on electric power cables.
Ensure that the electrical connection is protected against the
risk of water penetration in connectors. Use exclusively con-
nectors and couplings equipped with water spray protection.
- Never use inadequate or provisional electric lines: if in doubt
consult specialist personnel for assistance.
- Repairs to the electrical circuit must be performed exclusively
by specialised personnel. Disconnect the machine from the
power supply before performing maintenance or repairs.
-The electric cables may not touch any moving parts and/or
machine parts in motion, as in the event of damage, the metal
parts could be energised.
1.4

MORTAR HOSE

Only use identified mortar hoses with an operating pressure
of at least 40 bar.
Danger of injury through leaking mortar
hose. Wear and tear and links as well as
usage that is not appropriate to the purpo-
se of the device can cause leakages to form
in the mortar hose. Liquid can be injected
into the skin through a leakage.
Mortar hoses must be checked thoroughly before they are
used.
Replace any damaged mortar hose immediately.
Never repair defective mortar hoses yourself!
Avoid sharp bends and folds: the smallest bending radius is
about 80 cm.
Do not drive over the mortar hose. Protect against sharp ob-
jects and edges.
Never pull on the mortar hose to move the device.
Do not twist the mortar hose.
Lay the mortar hose in such a way as to ensure that it cannot
be tripped over.
Only use WAGNER original-mortar hoses in
order to ensure functionality, safety and du-
rability.
The risk of damage rises with the age of the
mortar hose.
Wagner recommends replacing mortar hoses
after 6 years.
GB
33