45 7.1.2 Pump In Unregulated Operation; Setting To Max-Characteristic Operation; 45 7.3 Setting To Min-Characteristic Operation; 45 7.4 Start/Stop Of Pump - Biral EBZ-E Notice De Montage Et D'utilisation

Pompes inline avec convertisseur de fréquence intégré
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

english
7.1.2 Pump in unregulated operation
Example:
In unregulated-operation mode, the pump performance
is set within the range from min. to max. curve, fig. 20.
H
Q
Fig. 20:
Pump performance setting, unregulated-operation mode

7.2 Setting to MAX-characteristic operation

Press
continuously to change to the MAX-characteristic
of the pump (top light field flashes). When the top light
field is on,
must be pressed for 3 seconds before the
light field starts flashing.
To return to unregulated or regulated operation, press
continuously until the desired setpoint is indicated.
H
Q
Fig. 21:
Max. curve duty
7.3 Setting to MIN-characteristic operation
Press
continuously to change to MIN-characteristic of
the pump (bottom light field flashes). When the bottom
light field is on,
must be pressed for 3 seconds before
the light field starts flashing.
To return to unregulated or regulated operation, press
continuously until the desired setpoint is indicated.
H
Q
Fig. 22:
Min. curve duty
7.4 Start/stop of pump
Stop the pump by continuously pressing
the light fields are activated and the green indicator light
flashes.
Start the pump by continuously pressing
desired setpoint is indicated.

8. External switching commands

The pump has inputs for the following external
switching commands:
– External ON/OFF
– Digital function
Caution

8.1 Input for external ON/OFF

Function diagram: input for external ON/OFF
External ON/OFF (terminals 2 and 3)
Function diagram: input for digital function:
Digital function
(terminals 1 and 3 – three-phase pumps)

9. BUS signal

The pump provides serial communication via an RS-485
interface. Communication is according to the GENIbus
protocol, and permits connection to a GLT or similar
system. (Possible types of control on request)
With the BUS signal it is possible to set pump operating
parameters such as reference value, mode of operation,
etc. from a remote point. At the same time the pump can
supply status information via the BUS for important
parameters, such as actual value of control parameter,
power consumption, fault indications, etc.

9.1 Connection modules for LONbus

Inquire to Biral Co.
until none of
until the
Pump internal voltage!
Use only zero-potential contact.
The pump status can only be regulated
or digital input.
H
Normal operation
Normalbetrieb
Q
H
Stop
Q
H
Normal operation
Normalbetrieb
Q
H
MIN characteristic
MIN-Kennlinie
curve
Q
H
MAX characteristic
MAX-Kennlinie
curve
Q
Stop
51

Publicité

Table des Matières
loading

Table des Matières