Programming Enable; Altering The Operating Programming Enable; Altering The Main Programming Enable - HYDAC ELECTRONIC ETS 300 Notice D'utilisation

ETS 300 11
9

Programming enable

The unit has 2 types of programming enable which must both be set to "ON" to change the
settings. The operating programming enable can be set or removed during operation. It provides
protection from unintentional alteration. A programming disable via the main programming enable
has the effect that no change to the settings can be carried out during operation. This serves, for
example, as a safety function or as protection against unauthorised alterations.

9.1 ALTERING THE OPERATING PROGRAMMING ENABLE

9.2 ALTERING THE MAIN PROGRAMMING ENABLE

Switch off supply voltage or disconnect the unit from the supply voltage.
Note:
• If a setting has been changed "PRG" is displayed briefly when the display is switched
over. The new setting is then saved in the unit.
Status: 29.01.2014 Part No.: 669651 E
HYDAC ELECTRONIC GMBH