Programming Enable; Altering The Operating Programming Enable; Altering The Main Programming Enable - HYDAC ELECTRONIC EDS 3000 Manuel D'instructions

setting
Version number (Version)
display of the current software version
(for reference only).
E
To close basic settings (End)
this closes the basic settings
menu.
basic settings can still be altered.
if the basic settings have been altered, "ProG" appears briefly when quitting
the basic settings menu, and then the selected display value is shown in the
primary display.
42
display setting pre-
range setting
yes/no no
7.

Programming enable

the unit has 2 types of programming enable which must both be set to "on"
to change the settings. the operating programming enable can be set or
removed during operation. it provides protection from unintentional alteration.
disabling the programming via the main programming enable means that the
settings cannot be changed during operation. this serves, for example, as a
safety function or as protection against unauthorised alterations.

7.1. altering tHe operating programming enable

7.2. altering tHe main programming enable

switch off supply voltage or disconnect the unit from the supply voltage.
note:
if a setting has been changed, "PROG" is displayed briefly when the display is
switched over. the new setting is then saved in the unit.
E
43