Changing The Main Programming Enable - HYDAC ELECTRONIC HNS 3000 Notice D'utilisation

HNS 3000

10.2 CHANGING THE MAIN PROGRAMMING ENABLE

CAUTION:
Switch off the supply voltage or disconnect the instrument from the supply
voltage.
HYDAC
→
3s
mode
Press and hold both
arrow keys
simultaneously.
Switch on the supply
voltage
(keep keys pressed
for 3 s)
(unchanged)
3 s
(changed)
3 s
NOTICE:
• Whenever any settings have been altered, "PROG" appears briefly in the
display when the display switches over. The new setting is then saved in the
unit.
Version 2018/07/06
→
0s
Display
(release
arrow keys)
Fluid level indication
Pressure
indicator
bar
Fluid level indication
Pressure
indicator
3 s
HYDAC ELECTRONIC GMBH
HYDAC
mode
Use the or keys to alter the
settings
FrEE = programming enabled
Loc = programming disabled
Page 19
Part No. 669927