Programming Enables; Altering The Operating Programming Enable; Altering The Main Programming Enable - HYDAC ELECTRONIC EDS 300 Notice D'utilisation

12

10 Programming enables

The unit has 2 types of programming enable which must both be set to "ON " to change the
settings. The operating programming enable can be set or cancelled during operation. It provides
protection against inadvertent changes to the unit's settings.
A programming disable via the main programming enable has the effect that no change to the
settings can be carried out during operation. This serves, for example, as a safety function or as
protection against unauthorised alterations.

10.1 ALTERING THE OPERATING PROGRAMMING ENABLE

mode
3 s
press both arrow
keys simultaneously
and hold down for 3 s

10.2 ALTERING THE MAIN PROGRAMMING ENABLE

Switch off supply voltage or disconnect the unit from the supply voltage.
mode
3 s "main program state"
press both arrow
keys simultaneously
and hold down.
Switch on supply
voltage (hold keys
down for 3 s)
Note:
• If a setting has been changed "PRG" is displayed briefly when the display is switched
over. The new setting is then saved in the unit.
Status: 19.09.2018
display use
(release ON = programming possible
arrow keys) OFF = programming disabled
display use
(release ON
arrow keys) OFF
HYDAC ELECTRONIC GMBH
mode
3 s
or to alter setting,
mode
or to alter setting,
= programming possible
= programming disabled
pressure
display
pressure
display
3 s
Part No.: 669648 E
EDS 300