Programming Enables; Changing The Operating Program Enable; Changing The Main Programming Enable - HYDAC ELECTRONIC ETS 3000 Notice D'utilisation

ETS 3000
9.

Programming Enables

The unit has 2 program enables which must both enabled in order for the settings to be
modified. The operating program enable can be set or cancelled during operation. It provides
protection against inadvertent changes to the unit's settings. Program disable via main
programming enable prevents any changes being made to the settings during operation.
This serves, for example, as a safety function or as a protection against unauthorized
alterations.
9.1

Changing the Operating Program Enable

HYDAC
bar
SP2
SP1
0 s
mode
Press both arrow keys
simultaneously and hold
down for 3 s
(Data not changed)
3 s
(Data changed)
3 s
9.2

Changing the Main Programming Enable

Switch off the supply voltage or disconnect the unit from the supply voltage.
HYDAC
SP2
SP1
3 s
mode
Display release arrow keys
Press both arrow keys
simutanously and hold
down. Then switch on
supply voltage and still hold down keys for 3 s
Note:
• If any settings have been changed, PRoG appears briefly in the display when the display
switches over. The new setting has then been saved in the unit.
Status 17.08.2016
bar
6 s
Display
release arrow
keys
Temp.display
bar
Temp.display
3 s
bar bar
0 s
Change setting with
HYDAC ELECTRONIC GMBH
bar
bar
2 s
Change settings with
FrEE
Loc
HYDAC
(Data not changed)
bar
SP2
SP1
(Data changed)
mode
or
= Programming enabled
FrEE
Loc = Programming disabled
Page 12
HYDAC
bar
bar
SP2
SP1
mode
or
= Programming enabled
= Programming disabled
Temp.display
3 s
bar
3 s
Temp.display
3 s
Part No.. 669859