Maintenance
Removal from Service/Winterization
1. Clean and sanitize the ice machine.
2. Turn off the water supply, disconnect and drain the
incoming ice-making water line at the rear of the ice
machine and drain the water trough.
3. Energize the ice machine, wait one minute for the
water inlet valve to open and blow compressed air in
both the incoming water and the drain openings in
the rear of the ice machine to remove all water.
4. Press the power button to turn off the ice machine &
disconnect the electric power at the circuit breaker
or the electric service switch.
5. Fill spray bottle with sanitizer and spray all interior
food zone surfaces. Do not rinse and allow to air dry.
6. Replace all panels.
46
Door Removal
1. Use a phillips screwdriver to loosen the two screws
securing the door. Do not remove they are secured
to prevent loss.
2. Open left front door to 90 degrees.
3
Door Removal
3. Support with right hand, depress top pin, tilt top of
door forward and lift out of bottom pin to remove.
Section 4
1
Part Number 000007924 5/14