Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Section 1
BIN INSTALLATION
•
All ice machines installed on a bin require an ice
deflector.
•
Manitowoc bins have a deflector installed and require
no modifications when used with a forward facing
evaporator.
•
Ice machines with multiple evaporators require a
deflector kit.
LUMINICE™
The LuminIce™ growth inhibitor recirculates the air in
the ice machine foodzone over a UV bulb. This process
will inhibit the growth of common micro-organisms on all
exposed foodzone surfaces.
•
LuminIce™ bulbs require replacement on a yearly
basis.
•
The control board can be set to automatically display
a reminder after 12 months. Refer to LuminIce™ in
section 3 for setup procedures.
Cleanup Procedure for Accidental Bulb Breakage
The cleanup procedure is identical to the procedure
used to clean up compact fluorescent (CFL) or
fluorescent tube lights. These lights contain a small
amount of mercury sealed within a glass tube. Breaking
these types of lights will release mercury and mercury
vapor. The broken bulb can continue to release mercury
vapor until it is cleaned up and removed.
The latest EPA procedures can be viewed on their
website at www.epa.gov/cfl/cflcleanup.html.
Part Number 000007924 5/14
DISPENSER INSTALLATION
•
Ice Beverage ice machines require an adapter for all
installations.
•
No adapter is needed for machines that match the
size of the dispenser unless required by the
dispenser manufacturer.
•
30" ice machines ship with the deflector/baffle
required for dispenser usage. No additional deflector/
baffle is required, unless specified by the dispenser
manufacturer.
•
A bin thermostat to control ice level is recommended.
CONTROL PANEL BEZEL
The ice machine ships with two bezels:
•
The standard bezel allows the display screen to be
viewed and the menu, arrows and checkmark
buttons can be accessed.
•
The key guard bezel allows the display screen to be
viewed and covers all buttons to prevent
unauthorized settings from being entered. The ice
machine door must be opened to access the control
panel.
To change the bezel, open the ice machine door, remove
the two screws securing the bezel and slide the bezel to
the right while lifting forward.
An optional cover that completely hides the display is
available as a sales kit, and is available through your
local distributor or service company.
General Information
9
Publicité
Chapitres
Table des Matières
