Preventative Maintenance Cleaning Procedure; Cleaning The Condenser - Manitowoc INDIGO NXT QUIETQUBE 816 Manuel D'installation, D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Section 4
Preventative Maintenance Cleaning
Procedure
This procedure cleans all components in the water flow
path, and is used to clean the ice machine between the
bi-yearly cleaning/sanitizing procedure.
Ice machine cleaner is used to remove lime scale and
mineral deposits. Ice machine sanitizer disinfects and
removes algae and slime.
NOTE: Although not required and dependant on your
installation, removing the ice machine top cover may
allow easier access.
Step 1 Ice must not be on the evaporator during the
clean cycle. Follow one of the methods below:
Press the power switch at the end of a harvest cycle
after ice falls from the evaporator(s).
Press the power switch and allow the ice to melt.
! Caution
Never use anything to force ice from the evaporator.
Damage may result.
Step 2 Open the front door to access the evaporator.
Step 3 Press the clean switch. Water will flow through
the water dump valve and down the drain. Wait until the
water trough refills and the display indicates add solution
(approximately 3 minutes), then add the proper amount
of ice machine cleaner.
Model
I06800C/I0870C/I0970C/
I1070C
IB0690C/IB0890C/IB1090C
I1470C/I1870C/I2170C
Step 4 Close and secure the front door. The ice
machine will automatically start ice making after the
clean cycle is complete (approximately 24 minutes).
Part Number 000007924 5/14
Amount of Cleaner
5 ounces (150 ml)
5 ounces (150 ml)
9 ounces (270 ml)

Cleaning the Condenser

!
Disconnect electric power to the ice machine head
section and the remote condensing unit at the
electric service switches before cleaning the
condenser.
A dirty condenser restricts airflow, resulting in
excessively high operating temperatures. This reduces
ice production and shortens component life.
Clean the condenser at least every six month.
!
The condenser fins are sharp. Use care when
cleaning them.
Shine a flashlight through the condenser to check for
dirt between the fins.
Blow compressed air or rinse with water from the
inside out (opposite direction of airflow).
If dirt still remains call a service agent to clean the
condenser.
Maintenance
Warning
Warning
45

Publicité

Chapitres

Table des Matières
loading

Table des Matières