Door Removal; Removing Lower Door Assembly; Reinstalling Lower Door Assembly; Ice Guide Adjustment - Manitowoc FC1350 Manuel D'installation, D'utilisation Et D'entretien

Installation Instructions

Door Removal

REMOVING LOWER DOOR ASSEMBLY

(Only if required for access through narrow doors)
1. With lower access door closed, remove Phillips
head screw and washer from hinge area on each
side of lower access door.
2. Insert screwdriver between door and hinge bracket
on one side of door and gently push against bracket
to provide room for door stud to clear bracket.
3. Remove access door.
4. Pull up on baffle to remove.
5. Remove three or four (3 or 4) screws along top of
door assembly.
6. Pull forward on assembly and remove.
ACCESS
DOOR
BAFFLE
LOWER DOOR
ASSEMBLY

REINSTALLING LOWER DOOR ASSEMBLY

1. Reinstall lower door assembly in bin opening.
2. Reinstall three or four (3 or 4) screws in hood at top
of door assembly.
3. Reinstall the baffle in side panel tracks and push
down to seat.
4. With door closed insert one door stud through hinge
bracket.
NOTE: For proper operation the access door must be
reinstalled in the closed position.
5. On other side, insert screwdriver between door and
hinge bracket and gently push against bracket to
provide room for door stud to clear bracket.
6. Reinstall washers and screws in lift door and tighten.
7. Check door to ensure proper operation.
6

Ice Guide Adjustment

Ice may flow over sides of cart when exiting hopper. Ice
guides hang down below hopper and help contain
flowing ice inside cart.
Guides are installed in highest position at factory,
providing 3/4" (19 mm) clearance to top of cart when
legs are in full down position. If legs are adjusted up
during leveling of Ice Transport System, ice guides
should be lowered to maintain 3/4" (19 mm) clearance.
Access to sides of Ice Transport System is required to
perform operation.
REPOSITIONING ICE GUIDES AFTER LEGS HAVE
BEEN ADJUSTED
1. Position cart (with totes, if so equipped) in bay below
shutter door opening.
2. Determine amount guides must be lowered to
maintain 3/4" (19 mm) clearance.
3. Remove thumbscrews holding guides.
4. Select hole to reposition guide at proper level and
resecure with thumbscrew.
5. Repeat process for each bay in system.
BRACKETS ON UNDERSIDE OF HOPPER
TO WHICH ICE GUIDES ARE SECURED
Section 2
Part Number 000006529 10/09