Removal From Service/Winterization - Manitowoc SD0302A Manuel D'installation, D'utilisation Et D'entretien

Maintenance
Exterior Cleaning
Clean the area around the ice machine as often as
necessary to maintain cleanliness and efficient
operation. Use cleaners designed for use with stainless
steel products.
Sponge any dust and dirt off the outside of the ice
machine with mild soap and water. Wipe dry with a
clean, soft cloth.
Heavy stains should be removed with stainless steel
wool. Never use plain steel wool or abrasive pads. They
will scratch the panels.
Door Removal
1. Use a phillips screwdriver to loosen the two screws
securing the left and right doors. Do not remove they
are secured to prevent loss.
2. 30 Inch and 48 Inch Models: To remove right front
door lift up and remove (22 inch ice machines have
a single door, lift to remove entire door).
4
Door Removal
3. Open left front door to 45 degrees.
4. Support with right hand, depress top pin, tilt top of
door forward and lift out of bottom pin to remove.
28
2
1
Cleaning the Condenser
GENERAL
!
Disconnect electric power to the ice machine head
section and the remote condensing unit at the
electric service switches before cleaning the
condenser.
A dirty condenser restricts airflow, resulting in
excessively high operating temperatures. This reduces
ice production and shortens component life.
• Clean the condenser at least every six months.
!
The condenser fins are sharp. Use care when
cleaning them.
• Shine a flashlight through the condenser to check for
dirt between the fins.
• Blow compressed air or rinse with water from the
inside out (opposite direction of airflow).
• If dirt still remains call a service agent to clean the
condenser.

Removal from Service/Winterization

1. Clean and sanitize the ice machine.
2. Move the ICE/OFF/CLEAN switch to OFF.
3. Turn off the water supply, disconnect and drain the
incoming ice-making water line at the rear of the ice
machine and drain the water trough.
4. Energize the ice machine, wait one minute for the
water inlet valve to open and blow compressed air in
both the incoming water and the drain openings in
the rear of the ice machine to remove all water.
5. Move ICE/OFF/CLEAN switch to OFF and
disconnect the electric power at the circuit breaker
or the electric service switch.
6. Fill spray bottle with sanitizer and spray all interior
food zone surfaces. Do not rinse and allow to air dry.
7. Replace all panels.
Section 4
Warning
Warning
Part Number 000006520 11/11