Maintenance; Interior Cleaning And Sanitizing; Cleaning/Sanitizing Procedure; Heavily Scaled Cleaning Procedure - Manitowoc RF Serie Manuel D'utilisation

Interior Cleaning and Sanitizing

Maintenance procedures covered in this manual are not
covered by the warranty.
,
Use only Manitowoc approved Metal Safe Ice Machine
Cleaner (part number 000000084) and Sanitizer (part
number 9405653). Do not mix Cleaner and Sanitizer
solutions together. It is a violation of Federal law to
use these solutions in a manner inconsistent with their
labeling. Read and understand all labels printed on
bottles before use.
n
Wear rubber gloves and safety goggles (and/or face
shield) when handling Ice Machine Cleaner or Sanitizer.

CLEANING/SANITIZING PROCEDURE

This procedure must be performed once every six months.
• All ice must be removed from the bin.
• The ice machine and bin must be disassembled, cleaned
and sanitized.
• The ice machine produces ice with the cleaner and
sanitizer solutions.
• All ice produced during the cleaning and sanitizing
procedure must be discarded.

HEAVILY SCALED CLEANING PROCEDURE

Perform this procedure if you have some or all of these
symptoms.
• Grinding, popping or squealing noises from the
evaporator.
• Grinding noise from gearbox.
• Ice machine trips speed sensor.
NOTE: A Cleaning/Sanitizing Procedure must be performed
after this procedure.

Exterior Cleaning

Remove dust and dirt off exterior surfaces with mild
household dishwashing detergent and warm water. Wipe
dry with a clean, soft cloth.
Part Number 000007644 Rev 01 12/16

Maintenance

Caution
Warning
Section 4
Cleaning/Sanitizing Procedure
Use Metal Safe Ice Machine Cleaner, part number
000000084.
Use Ice Machine Sanitizer part number 9405653.
Step 1
Remove front and top covers and set the toggle
switch to the OFF position.
Step 2
Remove all ice from the bin.
Step 3
Turn off the ice making water supply and drain
water from evaporator and reservoir.
Step 4 Remove the top cover from water reservoir.
Step 5 Follow the chart and premix cleaner and water.
Amount of Water
1 gallon (4 Liters)
Step 6
Fill the evaporator and reservoir with cleaning
solution.
Step 7
Move the toggle switch to the ON position. The
ice machine will make ice with the cleaning solution and
deposit the ice in the bin. Add the remaining cleaner/water
solution as the water level in the reservoir drops.
NOTE: Do not allow the cleaner/water level to drop below
the minimum water level. The ice machine will discontinue
the cleaning cycle if the water float switch opens.
Step 8 After all of the cleaner/water solution has been
added, turn on the ice making water supply. Continue the
freeze cycle for 10 minutes to remove the cleaning solution
from the water circuit.
Step 9
Place the toggle switch in the OFF position.
Amount of Metal Safe
Cleaner - Part Number
000000084
3 ounces (90 ml)
25