Boston Scientific Vercise Neural Navigator Mode D'emploi page 6

Vercise™ Neural Navigator Programming Manual
CAUTION: Use only Vercise PC DBS System components with Vercise Neural Navigator.
Failure to do so may result in the inability to program the Stimulator.
CAUTION: The CP is not equipment for the patient environment as defined by IEC 60601-1.
The CP and the person using the CP should not be in contact with the patient
while programming
Connecting the Programming Wand to the CP:
1. Power ON the CP.
2. Log into ClinicUser. You will be prompted to setup a password the first time you log into
the CP.
3. Connect the Programming Wand to the CP using the USB cable provided with the
Programming Wand. Plug the Mini USB end of the cable into the USB port on the side
of the Programming Wand and the Standard USB end of the cable into the USB port on
the CP.
4. The Wand will perform a short self-test. At the end of the self-test, the Wand will beep.
(a). If the Power Light on the Wand turns green, the Wand is ready for use.
(b). If the Power Light on the Wand remains red, contact a Boston Scientific representative,
or call Customer Service. For more information on the Programming Wand refer to the
Vercise DBS Programming Wand Manual.
5. Place Wand over the Stimulator.
Starting a Programming Session
Starting Vercise Neural Navigator
1. Power ON the CP and log in.
2. Click the Vercise Launcher icon
3. Select the Vercise PC DBS System icon
Note: The Bionic Navigator may also be accessed on the same CP using Vercise Launcher.
Refer to the Vercise DBS Reference Guide for instructions on which software application
to use with your Deep Brain Stimulation System. Refer to Vercise Programming Manual
with Bionic Navigator for instructions on the Bionic Navigator.
Note: Bionic Navigator and Vercise Neural Navigator should not be run simultaneously on the
same CP.
Vercise™ Neural Navigator Programming Manual
91046489-05 2 of 557
on the desktop.
to start Vercise Neural Navigator.