Table des Matières
Publicité
The Programming Screen
Once the leads have been configured, select the Program Tab to begin programming.
The Programming screen is divided into the following sections as seen in Figure 5:
#
Feature
1
Program Button
2
Program Options
Button
3
Area Panel
4
Delete Button
+
5
6
Stimulation ON/OFF
Button
7
Pulse Width Buttons
Figure 5. Programming Screen
Description
Select the Program that you would like to set up or adjust.
View battery longevity estimate, delete and copy programs and
change ramp and cycle times for Programs.
Select the Area within a Program that you would like to set up or
adjust.
Delete an Area within a Program.
Add an area. Select from one of the ports defined in the
Configure Tab.
Turn Stimulation OFF for the Area Selected.
Note: When the Amplitude is at 0mA, increase the Amplitude
to turn ON stimulation.
Adjust the pulse width.
Default
60 μS
Vercise™ Neural Navigator Programming Manual
Programming the Stimulator
Range
20 μS – 450 μS
91046489-05
7 of 557
Publicité
Table des Matières
