Vercise™ Neural Navigator Programming Manual
Elective Replacement Indicator (ERI) Message
You will not be able to connect to a non-rechargeable Stimulator that is nearing the end of its
battery life. The CP will display the Stimulator with an ERI message and the Stimulator battery
voltage as seen in Figure 14 on the Connect Tab. No changes can be made to the Stimulator
settings once it is in ERI.
Figure 14. ERI Message displayed on Connect Tab
End of Service (EOS) Message
When the Stimulator has reached its end of service, stimulation can no longer be provided. The CP
will display the message as seen in Figure 15 on the Connect Tab.
Figure 15. EOS Message displayed on Connect Tab
Ending a Programming Session
The Patient's Remote Control automatically syncs with the Stimulator that it has been linked to. No
additional steps need to be performed to copy programs from the Stimulator to the Remote Control.
Refer to Vercise Remote Control 2 Manual for more information.
To end a Programming Session on the CP:
1. Select the End Session Tab.
2. Select Exit Application to end the programming session and close the application.
3. Select Disconnect from Stimulator to end the programming session and disconnect from
the patient's stimulator. This will take you back to the Connect Tab.
Vercise™ Neural Navigator Programming Manual
91046489-05
22 of 557