Energy Yield - Fronius Primo 3.0-1 Instructions De Service

Contrast
Set the contrast on the inverter display
Setting range
Factory setting
Since the contrast is temperature-dependent, it may be necessary to adjust the setting
under the "Contrast" menu item when the environmental conditions change.
Illumination
Initial setting for inverter display illumination
The "Illumination" menu item only relates to the inverter display backlighting.
Setting range
Factory setting

ENERGY YIELD

The following settings can be changed/set here:
-
-
-
-
Setting range
Counter deviation / calibration
Calibrating the counter
Currency
Set the currency
Setting range
OFF: Fronius DATCOM will not run at night, the inverter therefore does not
require any power during the night to supply the Fronius Solar Net with
energy.
The inverter display is switched off during the night and the Fronius
Datamanager is not available. To nevertheless activate the Fronius
Datamanager, switch the inverter off and on again at the mains and press
any function button on the inverter display within 90 seconds.
0 - 10
5
AUTO / ON / OFF
AUTO
AUTO: The inverter display backlighting is activated by pressing any key. If no
key is pressed for 2 minutes, the display backlighting will go off again.
ON: The inverter display backlighting remains permanently on when the
inverter is active.
OFF: The inverter display backlighting is permanently switched off.
Counter deviation / Calibration
Currency
Feed-in tariff
CO2 factor
Currency / Feed-in tariff
3 characters, A-Z
33