Energy Yield - Fronius Primo 3.0-1 Instructions De Service

Illumination
Initial setting for display illumination
The "Illumination" menu item only relates to the display backlighting.
Setting range
Factory setting

Energy yield

Setting
-
-
-
-
Setting range
Meter deviation
Input of a value for the fed-in energy that will be added to the energy currently fed in (e.g.
carry-over value when replacing an inverter)
Unit
Setting range
Factory setting
Meter calibration
Input of a correction value to ensure that the value shown on the inverter display corre-
sponds with the calibrated display on the electricity meter
Unit
Setting range
Factory setting
Currency
Set the currency
Setting range
Feed-in tariff
Set the remuneration rate for energy fed into the grid
Setting range
Factory setting
34
AUTO / ON / OFF
AUTO
AUTO: The display backlighting is activated by pressing any key. If no key is
pressed for 2 minutes, the display backlighting will go off again.
ON: The display backlighting remains permanently on when the inverter is active.
OFF: The display backlighting is permanently switched off.
of an OFFSET value for the total energy display
of a measuring offset factor for the day, year and total energy display
of the currency
of the feed-in tariff
Meter deviation / Meter calibration / Currency / Feed-in tariff
Wh / kWh / MWh
Five digits
0
%
-5.0 - +5.0
0
3 characters, A-Z
2 digits, 3 decimal places
(depends on country setup)