Energy Yield - Fronius Symo Advanced Mode D'emploi

Contrast
Set the contrast on the inverter display
Setting range
Factory setting
Since contrast depends on temperature, it may be necessary to adjust the
'Contrast' menu item when environmental conditions change.
Illumination
Preset the inverter display illumination
The 'Illumination' menu item only applies to the inverter display background il-
lumination.
Setting range
Factory setting

Energy yield

The following settings can be changed/performed:
-
-
-
-
Setting range
Meter deviation/calibration
Meter calibration
Currency
Set the currency
Setting range
Feed-in tariff
Set the charge rate for the remuneration for energy fed into the grid
Setting range
40
OFF: No Fronius DATCOM operation at night, the inverter therefore does
not require any power to supply electricity to the Fronius Solar Net
at night.
The inverter display is deactivated at night and the Fronius
Datamanager is not available. To activate the Fronius Datamanager,
switch the inverter on the AC side off and back on and press any
function key on the inverter's display within 90 seconds.
0 - 10
5
AUTO / ON / OFF
AUTO
AUTO: The inverter display illumination is activated by pressing any key. If
no key is pressed for 2 minutes, the display backlight goes out.
ON: The inverter display illumination is permanently on when the invert-
er is active.
OFF: The inverter display illumination is permanently off.
Meter deviation/calibration
Currency
Feed-in tariff
CO2 factor
Currency / Feed-in tariff
3-digit, A-Z
2-digit, 3 decimal places