Energy Yield - Fronius Primo 3.0-1 Instructions De Service

Contrast
Set the contrast on the inverter display
Setting range
Factory setting
Since the contrast is temperature-dependent, it may be necessary to adjust
the setting under the "Contrast" menu item when the environmental conditions
change.
Illumination
Initial setting for inverter display illumination
The "Illumination" menu item only relates to the inverter display backlighting.
Setting range
Factory setting

ENERGY YIELD

The following settings can be changed/set here:
-
-
-
-
Setting range
36
ON: Fronius DATCOM mode is always in effect. The inverter supplies 12
V of DC voltage continuously to power the Fronius Solar Net. The
display is always active.
IMPORTANT! If Fronius DATCOM night mode is set to ON or
AUTO when there are Fronius Solar Net components connected,
the inverter's current consumption during the night will increase to
around 7 W.
OFF: Fronius DATCOM will not run at night, the inverter therefore does
not require any power during the night to supply the Fronius Solar
Net with energy.
The inverter display is switched off during the night and the Fronius
Datamanager is not available. To nevertheless activate the Fronius
Datamanager, switch the inverter off and on again at the mains and
press any function button on the inverter display within 90
seconds.
0 - 10
5
AUTO / ON / OFF
AUTO
AUTO: The inverter display backlighting is activated by pressing any key. If
no key is pressed for 2 minutes, the display backlighting will go off
again.
ON: The inverter display backlighting remains permanently on when the
inverter is active.
OFF: The inverter display backlighting is permanently switched off.
Counter deviation / Calibration
Currency
Feed-in tariff
CO2 factor
Currency / Feed-in tariff