Energy Yield - Fronius Symo Serie Instructions De Service

Contrast
Set the contrast on the inverter display
Setting range
Factory setting
Since contrast depends on temperature, it may be necessary to adjust the 'Contrast'
menu item when environmental conditions change.
Illumination
Preset the inverter display illumination
The 'Illumination' menu item only applies to the inverter display background illumination.
Setting range
Factory setting

Energy Yield

The following settings can be changed/performed:
-
-
-
-
Setting range
40
AUTO: The Fronius DATCOM operation is maintained as long as a Fronius Data-
manager is connected to an active, uninterrupted Fronius Solar Net.
The inverter display is dark during the night and can be activated by pressing
any function key.
ON: The Fronius DATCOM operation is always maintained. The inverter pro-
vides an uninterrupted 12 V DC voltage to supply Fronius Solar Net with
power. The display is always active.
IMPORTANT! When the Fronius DATCOM night mode is ON or on AUTO
with connected Fronius Solar Net components, the power consumption of
the inverter at night increases to around 7 W.
OFF: No Fronius DATCOM operation at night, the inverter therefore does not re-
quire any power to supply electricity to the Fronius Solar Net at night.
The inverter display is deactivated at night and the Fronius Datamanager is
not available. To activate the Fronius Datamanager, switch the inverter on
the AC side off and back on and press any function key on the inverter's dis-
play within 90 seconds.
0 - 10
5
AUTO / ON / OFF
AUTO
AUTO: The inverter display illumination is activated by pressing any key. If no key
is pressed for 2 minutes, the display backlight goes out.
ON: The inverter display illumination is permanently on when the inverter is ac-
tive.
OFF: The inverter display illumination is permanently off.
Meter deviation/calibration
Currency
Feed-in tariff
CO2 factor
Currency / Feed-in Tariff