Energy Yield; Fan - Fronius Primo 3.0-1 Instructions De Service

Since the contrast is temperature-dependent, it may be necessary to adjust the setting
under the "Contrast" menu item when the environmental conditions change.
Illumination
Initial setting for inverter display illumination
The "Illumination" menu item only relates to the inverter display backlighting.
Setting range
Factory setting

ENERGY YIELD

The following settings can be changed/set here:
-
-
-
-
Setting range
Counter deviation / calibration
Calibrating the counter
Currency
Set the currency
Setting range
Feed-in tariff
Set the remuneration rate for energy fed into the grid
Setting range
Factory setting
CO2 factor
Setting the CO2 factor of the energy fed into the grid

Fan

To check that the fan is working correctly
Setting range
-
-
-
IMPORTANT! Nothing will show on the inverter display if the fan is working. The only way
to check how the fan is working is by listening and feeling.
AUTO / ON / OFF
AUTO
AUTO: The inverter display backlighting is activated by pressing any key. If no key
is pressed for 2 minutes, the display backlighting will go off again.
ON: The inverter display backlighting remains permanently on when the inverter
is active.
OFF: The inverter display backlighting is permanently switched off.
Counter deviation / Calibration
Currency
Feed-in tariff
CO2 factor
Currency / Feed-in tariff
3 characters, A-Z
2 digits, 3 decimal places
(depends on country setup)
Test fan #1 / Test fan #2 (depending on the device)
Use the "Up" and "Down" keys to select the desired fan
Testing of the selected fan is initiated by clicking "Enter".
The fan will continue to run until the operator exits the menu by pressing "Esc".
33