Energy Yield; Fan - Fronius Primo 3.8-1 208-240 Instructions De Service

Energy Yield

Setting
-
-
-
-
Setting range
E-meter offset
Specification of a value for the energy supplied that is added to the currently supplied en-
ergy (e.g., the transfer value when an inverter is replaced)
Unit
Setting range
Factory setting
E-meter calibration
Specification of a correction value so that the data shown on the inverter display corre-
spond to the calibrated data shown on the electric meter
Unit
Setting range
Factory setting
Currency
Currency setting
Setting range
Feed-in tariff
Charge rate setting for the energy fed into the grid
Setting range
Factory setting

Fan

for checking the fan functionality
Setting range
-
-
-
30
an OFFSET value for the Total energy display
a measurement correction value for the day, year and total energy display
the currency
the feed-in tariff
E-meter offset/E-meter calibration/Currency/Feed-in tariff
Wh/kWh/MWh
5-digit
0
%
-5.0 to +5.0
0
3-digit, A-Z
2-digit, 3 decimal places
(depends on the country setup)
Test fan #1 / Test fan #2
Use the "Up" and "Down" keys to select Test fan #1
Press the "Enter" key to start testing of the fans
The fans run until the menu is exited by pressing the "Esc" key