Drive Mode; Before Starting; Remote Control - Reely ROAD Promotion 30 Notice De Montage

Risk of explosion! Fire danger!
•
Car fuel is highly flammable. When fuelling the car, do not smoke; no open fires!
•
Stock fuel in well ventilated rooms, away from ignition sources.
•
Only transport the vehicle (e.g. in the car) with an emptied tank. Escaping vapors are a health hazard! There is furthermore a danger of fire and explosi-
on!
•
Fuel and oil residues can soil, e.g. the boot of your vehicle. This is why you should think about using a suitable surface or use a transport case. Transport
the vehicle separate from all component parts in order to avoid getting, eg the remote control dirty.
•
Empty the tank if you do not want to drive the mode for several days.
•
Use appropriate containers for transporting the fuel.
•
The fuel can eat away and damage varnish and rubber parts.
•
Don't let any fuels or oils get in the environment. Never pour fuels in the nature or down the drain! Dispose of them in an environmentally friendly way,
e.g. via problem waste collection.
•
Empty fuel containers are a hazardous waste and must be recycled accordingly.
•
Do not burn fuel containers!
c) Drive mode:

Before starting:

Check all bolted connections and all wheel nuts.
Make sure that the rechargeable batteries (batteries) of both transmitter and receiver are completely charged.
1. Both control levers in neutral position, . Switch on remote control transmitter and 3. Receiver
•
During the starting process the wheels of the vehicles must not be on the ground. We recommend the use of a start box onto which the vehicle can be
placed. Place the vehicle in a way so that the wheels and drive can move freely (do not touch the drive!).
When starting the engine, the centrifugal clutch might get activated at higher engine speed; the wheels suddenly start to turn!
Never drive if your ability to respond is limited (e.g. when tired, under medication or under the influence of alcohol).
Incorrect responses can cause serious damages to people and objects.
•
Do not drive in the direction of gathered people, persons or animals!
•
Always keep visual contact to your model! Do not drive at night.
•
Please note that this model vehicle must not be driven on public roads or streets. Only operate it on private sites or places which are specifically designa-
ted for this purpose. Take note of possible conditions and regulations for the site.
•
Because of the high noise level, you should not drive the vehicle in residential areas or in places where people might be bothered by the noise.
•
Do not drive the vehicle in nature reserves or near them or in locations inhabited by animals.
•
Never drive without air filter!
•
Check regularly all bolt connections and fasteners, as they may get loosened or detached due to the vibrations of the engine.
•
Avoid long driving in the part-load operational range, since otherwise, engine and clutch (missing air cooling) will overheat!
•
Avoid driving at very low outdoor temperatures.
•
The synthetic material of the car body loses its elasticity; Therefore, even small collisions may cause chippings and fractures.
•
Don't drive in the rain, through wet grass, paddles, water, mud or snow. Although the RC box protects the receiver from dust and dirt, all the other compo-
nents of the vehicle are exposed to all conditions of driving (servo, carburetor, drive parts etc.).
d) Remote control:
•
Before starting, check the range of your remote control system.
•
Firmly screw the transmitter antenna and pull it out to its entire length.
•
An antenna that is not completely pulled out reduces the range of the remote control transmitter.
•
Check, on the stationary model, whether the servos respond to the signal of the remote control!
•
Check the charge level indicator of your remote control!
•
When the rechargeable battery is low (or the normal batteries) the range of transmission is reduced; it furthermore no longer responds correctly to the
commands of the remote control.
•
In this case, stop drive operation immediately, switch off the combustion engine. Afterwards replace the batteries or rechargeable batteries in the vehicle
(receiver current supply) or in the transmitter with new ones.
•
Make sure that nobody else is transmitting in the proximity of your frequency!
Interfering signals on the same frequency can make you lose the control over your model.
Also, when using different modulation types (FM, PPM, AM, PCM), the same frequencyshould not be used.
•
Do not drive under high voltage power lines or radio masts.
•
Do not drive in the case of thunderstorms!
Atmospheric interferences can affect the signals of your remote control transmitter.
•
Make sure that the throttle/brake servo is in idle position.
•
Always let the remote control and the receiver turned on whilst the engine is running!
Switching off: 1. switch off the engine, . the receiver then the transmitter!
•
Only experts may undertake repair operations on a defective remote control system. Unauthorized intervention with the electronic system will lead to
cancellation of the license of the remote control system.
© REELY 03/09
37 37 37