6. Remove lead stylet prior to folding the lead for fixation.
7. Gently fold the lead over and place it inside one of the four lead exit slots.
CAUTION: Secure the Lead using a lead exit slot that is approximately perpendicular to the Retaining
Clip channel.
8. Optional: The Lead may be secured to additional Lead Exit Slots.
Cap Placement
1. Insert the Cap into the Base by aligning the arms of the Cap with the Cap Slots in the Base.
Note: You may need to push inward on a Cap arm in order to complete Cap insertion.
Instructions for Use
Burr Hole Cover Directions for Use
91062297-02 REV A 5 of 237