Boston Scientific SureTek DB-4600-C Mode D'emploi page 8

Burr Hole Cover Directions for Use
2. Attach the Retaining Clip to the horseshoe end of the Placement/Removal Tool.
The post and the tab on the horseshoe end of the Placement/Removal tool line up with the clip release
hole and closure dimple.
CAUTION: Do not adjust the horseshoe end of the Placement/Removal Tool after the Retaining Clip
has been attached.
3. While stabilizing the lead, carefully position the Retaining Clip over the Base so that the lead is located
in the Retaining Clip's open channel. Position the Retaining Clip so that the static side of the opening
is against the lead.
4. Push the Retaining Clip down into the Base. Make sure that the Retaining Clip is completely seated in
the Base.
5. Place the tip end of the Placement/Removal Tool into the closure dimple or anywhere along the length
of the Slider on the Retaining Clip to push the Slider towards the Lead until it locks into place. Use the
tip end of the Placement/Removal Tool to apply pressure on the Slider face in the opposite direction to
ensure that the Slider is fully locked.
Burr Hole Cover Directions for Use
91062297-02 REV A 4 of 237