Operating Menus And Input Window; System Parameters; Remote Function; Functional Elements Of The "Remote" Function - Sartorius Stedim Biotech CERTOMAT CTplus Mode D'emploi Original

8.3

Operating menus and input window

8.3.1 "System Parameters"

After pressing the "System Parameters" key and
subsequent entry of the standard password the
following settings can be carried out:
Field Value
hh:mm:ss
Time
yyyy-mm-dd
Date
hh:mm:ss
Failtime
IP address
Internet
Config
enable/disable
Beeper
8.3.2 "PV Ranges"
Only authorised personnel (service technicians) are
allowed to make settings here in this menu.
8.3.3 "Calibration"
Only authorised personnel (service technicians) are
allowed to make settings here in this menu.
8.3.4 "Service"
Only authorised personnel (service technicians) are
allowed to make settings here in this menu.
8.3.5 "Manual Operation"
Changes to settings may only be carried out for test
purposes in agreement with the technical service
department.
Settings in manual mode have the highest priority; they
have priority over the other functions on the associated
control elements of the DCU system.
44
Function
Entry of current time, in
"hours:minutes:seconds"
format
Entry of current date, in
"year-month-day"
format
Entry of power failure
time for the system
behaviour when it is
switched on again
Configuration of the
Ethernet interface for
the connection of
external DP facilities,
e.g. via the LAN into the
laboratory
Switch-on or switch-off
of the acoustic alarm
signal, affects all alarms
9

"Remote function"

The remote mode is activated or deactivated by
pressing the "Remote" key.
Fig. 36: "Remote" function of the
CERTOMAT® CTplus
9.1

Functional elements of the "Remote" function

Key, Symbol Meaning, Use
Remote mode is deactivated.
There is no communication
between the external control
unit and DCU4 control unit.
The remote control is
deactivated. The operator cannot
access the DCU4 control unit
from an external control unit
(e.g. MFCS/win).
Remote mode is activated.
Communication between the
external control unit and DCU4
control unit takes place. The
bidirectional control unit is
activated. Remote control of the
DCU4 control unit is possible.