Sartorius Stedim Biotech CERTOMAT CTplus Mode D'emploi Original page 100

5.2.2 Entering the speed
- Press the "SHAKER" key.
The input menu of the speed controller appears.
Fig. 19: "Controller SHAKER" menu
- Enter speed (50 rpm) via the screen keypad, set the
"Mode" to "auto" and confirm with "ok".
5.2.3 Switching the working illuminance on or off
- Press the "LIGHT" key.
The input menu for the working illuminance appears.
Fig. 20: Entry LIGHT "On"/ "Off"
- Switch off working illuminance by pressing "Off".
24
The shaking operation starts.
The "SHAKER" key shows the
green underline for operating
mode "auto" and the entered
speed (50 rpm) is displayed.
.
The working illuminance is
switched off.
The "LIGHT" key indicates the
grey underline for operating
mode "Off".
5.2.4 Switching the photo illuminance on or off
Caution:
With installed illumination unit only
(option, see Chap. 1.2.3)
- Press the "ILLUM" key.
The input menu for the photo illuminance (ILLUM)
appears.
Fig. 21: Entry ILLUM "On"/"Off"
- Switch off photo illuminance by pressing "Off".
5.2.5 Entry of CO concentration
2
- Press the "CO " key.
2
The input menu for the CO
Fig. 22: Entry of CO
- Enter the CO concentration (5%) on the screen
2
keypad, set "Mode" to "auto" and confirm with "ok".
The photo illuminance is
switched off.
The "ILLUM" key shows the grey
underline for the "Off"
operating mode.
concentration appears.
2
concentration
2
The CO concentration is set.
2
The "CO " key shows the green
2
underline for a CO
2
concentration of 5%.