Sartorius Stedim Biotech CERTOMAT CTplus Mode D'emploi Original page 111

Step
Define step 1
Enter operating time of
step 1.
Enter operating time
[hh:mm] via screen keypad.
Input of the duration is basically made in hours and minutes [hh:mm]. After input, operating times greater than 24 h are
automatically converted into days, hours and minutes.
The remaining values (speed, temperature, cooling and photo illuminance) for the programming of step 1 must be entered in
the same way as the programming of the Pre-step.
Define steps 2, 3 and 4
The values for the programming of steps 2, 3 and 4 must be entered in the same way as the programming of the Pre-step or
step 1.
If steps 2, 3 and 4 are not required, the running time (duration) of the respective step must be set to "0".
Leave "Batch Parameters"
menu.
Key, Symbol, Display Input
Press "Value" key in "Step 1" line / "Duration"
column.
Enter operating time [hh:mm] via screen keypad
and confirm with "ok" key.
Press "Close" key.
35