Publicité
4. Push the ON button (A) on the power pack. There is
a fixed green light on the LEDs (1, 2, 3).
A
1
2
3
To start the remote control
1. Push the ON/OFF button to start the remote control.
The display shows the home view for when the
motor is off. Refer to
2092 - 003 - 08.08.2024
Home view on page 38 .
To start the blade rotation
1. Use your left hand to push the start/stop switch (A)
to the right and hold it.
A
2. Use your right hand to push down the knob for blade
speed adjustment (B).
3. When the saw blade starts to operate, let go of the
start/stop switch and the knob.
4. Turn the blade speed adjustment knob (C) to adjust
the speed of the blade.
To stop the product
WARNING:
supply to the product when it is not
connected to the power supply.
1. Feed the blade out of the wall while it rotates. Feed
the saw arm to its top position.
2. Push the start/stop switch to the left to turn
off the blade rotation. The blade rotation can
also be stopped by turning the adjustment knob
counterclockwise.
3. Turn off the water flow.
4. Make sure that the cut blocks are secured with
wedges to make sure that they do not fall out during
disassembly.
5. Move the saw to a suitable work position for
disassembly.
6. Push the ON/OFF button on the remote control to
stop the wall saw.
B
C
Always close the water
33
Publicité
