Publicité
7. Guide the blade up on the center guide and place
it against the inner blade flange. Hold the blade in
place and then mount the outer blade flange with the
blade bolt and tighten to 45 nm.
B
C
A
8. Use a large set square and make sure that the
angle between the blade (A) and the wall (B) is
perpendicular. If the blade is not perpendicular to the
wall, loosen the locking screw for angle adjustment
and angle the mounting brackets until the blade is in
a perpendicular position.
B
2092 - 003 - 08.08.2024
D
A
9. Angle both mounting bracket halves in relation to
each other.
WARNING:
is correctly attached before you start the
product.
To assemble the blade guard
WARNING:
from the power supply before you start the
assembly.
The blade guard consists of three sections.
•
One center section which is mounted on the saw unit
•
Two outer sections which are mounted on the center
section. The outer sections are equilateral and may
be fitted on either side of the center section.
1. Push the blade guard guide between the pipes on
the blade guard.
2. Make sure that the guide rollers on the blade guard
guide roll easily between the pipes.
3. If the blade guard guide has play between the pipes,
the guide rollers must be adjusted. Refer to
adjust the blade guard guide on page 44 .
Make sure that the blade
Disconnect the product
To
23
Publicité
