Publicité
8. When you cut the rebar (C) longitudinally, you must
cut the rebar according to the illustration in order
to create a smaller cutting surface and to keep the
blade sharp. You can also start to cut from the other
end of the cut since it is not certain that the rebar
follows the cut the whole way.
C
Note:
A lower rotation speed of the blade
decreases the risk of polished blade in hard
materials.
9. Use maximum longitudinal feeding speed for optimal
sawing performance. The software in the power pack
continually and automatically regulates the feeding
for optimal sawing performance.
10. When over cutting is not allowed, you should use
a hand cutter after a completed wall cutting, and
from the rear of the concrete block cut out the uncut
distance (wedge). Use the PRIME power cutters,
connected to the lower outlet on PP 8. The transport
trolley also has a designated place for a hand cutter.
11. Remove the blade from the sawing groove after
each cut.
12. After you have finished to wall saw, feed the blade
fully out of the sawing groove and shut down the
blade rotation and water flow.
CAUTION:
rotate without pressure on the blade
segments for an extended period.
This will make the blade dull.
13. Stop the power pack and the water flow.
To cut blocks
WARNING:
heavy and can cause serious injury if
not handled properly. Make sure that the
block is secured safely before the operation
begins.
The cutting arm can be angled in the positions below.
1. Examine the dimensions of the block and make sure
that you have the correct equipment to safely lift and
remove the block.
30
C
Do not let the blade
Concrete blocks are very
2. Divide a large block into smaller parts if it is
necessary.
3. Put the holes for the mounting brackets at a distance
of approximately 150 mm / 5.9 in. (A) from the cut.
A
A
A
A
A
A
WARNING:
mounting brackets to a part of the block
that is to become loose at the next
cutting operation.
Note:
When you place the holes according to the
illustration it is possible to use the same holes for
both horizontal and a vertical cuts.
Note:
You can mount the saw on both sides of the
track so that two cuts can be made with the same
mounting bracket setup.
Note:
The holes should be drilled for the M10
expansion bolts according to the bolt manufacturer's
recommendations.
4. Cut the block in a sequence according to
the illustration. The illustration shows the work
procedure when you divide a block into 3 sections.
E
a) Do the horizontal cuts first. Start from the bottom:
(A), (B), (C), (D).
A
A
A
A
A
A
Do not attach the
D
C
E
B
A
2092 - 003 - 08.08.2024
Publicité
