Publicité
2. Put the other end of the CAN bus cable in the
connector (B) on the power pack.
3. Tighten the connector screws for the CAN bus cable
by hand.
To operate the product with the remote control
connected with a CAN bus cable
In certain circumstances it is mandatory to connect
a CAN bus cable to operate the product. For more
information, contact your Husqvarna service center.
The radio signal transmission stops when the remote
control is connected with the CAN bus cable.
•
Connect the CAN bus cable between the remote
control and the product. Refer to
remote control to the power pack with a CAN bus
cable on page 35 .
To control if the pairing is active
1. Start the remote control. Refer to
remote control on page 36 .
2. Start the power pack. Refer to
pack on page 32 .
3. The pairing is still active if the connection strength is
visible in the information display.
Remote control
The product is operated with a remote control.
The remote control can operate by radio signal
transmission. If there is an interference in the
transmission, the frequency changes automatically. A
pairing operation between the product and the remote
control is done by the factory. A new pairing operation
is necessary if the remote control is replaced or if you
change remote controls between products. Refer to
do a pairing operation between the remote control and
the power pack on page 34 .
The remote control can also operate with a CAN bus
cable connected between the remote control and the
product. The CAN bus cable that comes with the product
is 10 m. The maximum length for the CAN bus cable
is 30 m. The CAN bus cable can for example be used
when the state of charge in the remote control battery
is low or when no remote control battery is installed.
For instructions on how to connect the remote control to
the product with a cable, refer to
control to the power pack with a CAN bus cable on page
35 .
36
To connect the
To operate the
To start the power
To
To connect the remote
The remote control has all controls that are necessary
to operate the product. The remote control has a digital
display with a menu system. Refer to
page 38 .
To operate the remote control
The product is controlled with the remote control. The
remote control is connected to the power pack through
radio transmission or through the CAN cable.
•
Push the ON/OFF button to start and stop the
remote control.
•
Turn the knob to move the wall saw longitudinally
along the track.
Menu system on
2092 - 003 - 08.08.2024
Publicité
