Publicité
Introduction
WARNING:
product, you must read and understand the
safety chapter.
•
If you are going to use the wall saw WS 8, read:
•
Maintenance of PP 8, WS 8 and remote control
•
If you are going to use another power tool that
is compatible with the power pack PP 8, read the
Maintenance section in this manual only regarding
the power pack PP 8. For other questions, read the
other power tool's manual.
General product maintenance
WS 8
Clean the wall saw and accessories. Refer to
Clean the connectors on saw head and HF-cable.
Make sure that all external couplings, connections and cables are not damaged.
Make sure that the locking handles operates correctly. Make sure that the wheels are adjus-
To adjust the guide wheels on page 44 .
ted correctly. Refer to
Do a check of the flange hub for damage or wear.
Do a check of the blade guard(s) for damage or wear.
Make sure that the blade guard guide is adjusted correctly. Refer to
guide on page 44 . Lubricate the locking mechanism.
Do a check of the racks on the tracks for damage. Make sure that the screws that hold the
racks are tightened.
Make sure that all guide wheels are rotating smooth without excessive play. If there is
excessive play, Speak to an approved Husqvarna service center.
Listen for abnormal sounds from the feeding motors and the pivoting arm.
Connect all water connections, turn on the water and look for water leakage.
PP 8
Clean the power pack and accessories. Refer to
Do a overall check of the Power Pack for cracks or broken parts.
Make sure that the machine stop button operates correctly. Refer to
power pack emergency stop button on page 15 .
Remote control
Clean the remote control and accessories. Refer to
44 .
Do a overall check of the remote control for cracks or broken parts.
42
Maintenance
Before you operate the
To clean the power pack on page 43 .
To clean the power pack on page 43 .
To clean the remote control daily on page
Maintenance schedule
WARNING:
from the power supply and wait minimum 5
minutes before you start the maintenance.
WARNING:
washer to clean the products. The high
pressure can cause damage to the seals
and cause water and dirt to come into the
products.
To adjust the blade guard
To do a check of the
Disconnect the products
Do not use a high pressure
Daily
Weekly
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
2092 - 003 - 08.08.2024
Publicité
