Publicité
4. Push the TEST button (blue).
5. The RCD must trip, the product must stop
immediately and all LED ligths must go off. If not,
speak to your Husqvarna dealer.
6. Push the RESET button (green).
Blade guard
The blade guard keeps dust away from the operator and
prevents injury if the cutting blade breaks.
WARNING:
without a blade guard.
The outer sections can be removed for near floor
operations.
Blade guard lock
The blade guard lock keeps the blade guard guide in
the correct position on the blade guard. Make sure the
screw for the blade guard guide is fastened when the
blade guard is fitted.
2092 - 003 - 08.08.2024
Do not use the product
To do a check of the blade guard lock
•
Make sure that the blade guard lock mechanism on
the blade guard guide operates correctly. Refer to
Blade guard lock on page 17 .
End stops
The end stops (A) prevent the product to come off the
tracks. Make sure that the end stops are mounted on the
ends of the tracks so that the saw does not come off
To assemble the track connectors
the tracks. Refer to
on page 19 .
WARNING:
attached correctly to the track ends, the
product comes off and can cause serious
injury.
To do a check of the end stops
•
Make sure that end stops are attached to the track
Wall saw overview on page 4 .
ends. Refer to
Safety instructions for maintenance
WARNING:
instructions that follow before you do
maintenance on the product.
•
Not approved changes and/or accessories can
cause serious injury or death to the operator or
others.
•
Do the daily maintenance to make sure that the
product operates correctly. Refer to
schedule on page 42 .
•
Do the inspection and/or maintenance with the motor
stopped and the power plug disconnected.
A
If the end stops are not
Read the warning
Maintenance
17
Publicité
