Publicité
1234
WHAT IT IS ABOUT
WHAT IT DOES
WHAT YOU SHOULD DO IS MOST OF THE TIME
DESCRIBED IN TWO ROWS BUT IN SOME CASES
IT MIGHT BE NEEDED WITH THREE
Use the accept button (C) to remove the warning from
the full scren. If there is more than 1 active message,
use the arrow buttons (D and E) to move between the
messages in the display. You can also find a fault list
in the "Active faults" in "Machine status" with the menu
Machine status menu on page 39 .
button (F). Refer to
1234
WHAT IT IS ABOUT
WHAT IT DOES
WHAT YOU SHOULD DO IS MOST OF THE TIME
DESCRIBED IN TWO ROWS BUT IN SOME CASES
IT MIGHT BE NEEDED WITH THREE
F
Different types of error messages
There are 4 different types of error messages:
•
Information messages help and give hints on how to
operate the product. This message is a white speech
bubble.
•
Caution messages show that something is not
correct. A caution message is a yellow triangle.
Troubleshooting - wall saw and power pack
Error / info
code
-
-
46
A
B
C
D
E
Message
The cutting depth is too large.
The blade speed is too high.
The water flow to the blade is
too high.
The blade is too hard.
•
Warning messages show faults or safety errors that
can cause mechanical damage. The product will
stop in a short time. The warning is first shown in
full screen with a red warning triangle and text. After
you accept (C) the warning message, the warning
becomes a red triangle symbol in the bottom bar (A).
•
Error messages show when the product is stopped
because of a fault or safety error. The error message
is shown in red with a white triangle and white text.
When you accept (C) the error message, the triangle
symbol is shown in the bottom bar (A).
Error messages
If there are errors, an error code and an error message
are shown on the display of the remote control.
An error message has 4 parts. The message has one
warning triangle (A), information about the warning (B),
what the warning does (C) and also information about
what you should do (D).
1234
WHAT IT IS ABOUT
D
WHAT IT DOES
WHAT YOU SHOULD DO IS MOST OF THE TIME
DESCRIBED IN TWO ROWS BUT IN SOME CASES
IT MIGHT BE NEEDED WITH THREE
Do the procedure shown on the display or speak to your
Husqvarna service center. Push the "OK" button to close
the error message.
If you close the error message and it does not show
on the display again, you can continue to operate the
product.
If the error message shows again, refer to
Troubleshooting - wall saw and power pack on page 46
or speak to your Husqvarna service center. If necessary,
do an update of the software of the product.
If there are error messages not explained in this manual,
speak to your Husqvarna service center.
Cause
A
B
C
Action
Decrease the cutting depth.
Decrease the blade speed.
Decrease the water flow to the
blade.
Change the blade to a softer
blade.
2092 - 003 - 08.08.2024
Publicité
