Publicité
a) On the underside of the track ends that you will
connect are excenter bolts attached. To unlock
them, turn them counterclockwise (A).
b) Remove the excenter bolts (B).
c) Remove the end stoppers (C).
B
2. Mount the splice connector.
a) Place the splice connector between the two track
ends and push the track ends together until they
meet (A). The ends must be flush in the center of
the connector.
b) Place the excenter bolts (B) in the holes on the
underside of the rail. Make sure that the marking
on the bolt is centered over the symbol with the
open padlock. The bolt should be pushed in all
the way so that the head is flat against the rail.
c) Turn the bolts (C) clockwise towards the symbol
with the locked padlock to lock them. Tighten to
40 Nm.
B
3. Mount the end stopper.
a) Place the end stopper (A) in the end of the rail.
20
C
C
A
B
A
A
C
B
b) Place the excenter bolt (B) in the hole on the
underside of the rail. Make sure that the marking
on the bolt is centered over the symbol with the
open padlock. The bolt should be pushed in all
the way so that the head is flat against the rail.
c) Turn the bolt (C) clockwise towards the symbol
with the locked padlock to lock them. Tighten to
40 Nm.
A
C
To assemble the tracks
1. Make sure that the expander bolt does not extend
beyond the surface of the rail on the mounting
bracket.
2. Snap the rail into both mounting brackets. Adjust the
position of the rails lengthwise.
B
A
B
2092 - 003 - 08.08.2024
Publicité
